5.3 “PBR” PANEL FOR GENERAL STEEL BUILDINGS

The “PBR”STEEL BUILDING panels are designed for roof application, but may on occasion be installed on the wall. The profile is the same as the “R” panels except for the addition of the support leg on the leading edge on one side. Erection of this panel requires that the proper direction of its application be established. The support leg allows for better nesting with the overlapping rib of the next panel. As shown below, the installation of the panels would proceed from left to right.

PANEL LAP

DANGER:

Do not step on major ribs, the side edge, or the edge of the "R" Panel. Always follow OSHA safety regulations. SAFETY FIRST!