5.2 GENERAL STEEL “R” PANEL

The “R” panels are designed for both roof and wall applications. Its symmetric profile allows for installation without regard to sheeting direction. Sheeting can be started from either end of the steel building; however, by applying the sheets toward the direction of the prevailing view, the overlap line on the side of every third rib will be less visible. Where heavy prevailing winds occur, place the edge to be lapped into the wind!

PANEL LAP

DANGER:

Do not step on major ribs, the side edge, or the edge of the "R" Panel. Always follow OSHA safety regulations. SAFETY FIRST!

PBR Panels >>